S-Series Rear Brake Kit for Early Big Ford Ends, 2.332" Offset, Hard Metallic Brake Pads

(No reviews yet) Write a Review


Designed Specifically For Drag Racing

Rear brake kit for Big Ford housing ends – H1135
Brake offset = 2.332″
Maximum axle flange OD = 6.245″

For Big Ford housing ends with 2.500″ brake offset- See B6707WC

Rotor is centered by the wheel studs
Center hole is 3.250″ to clear all common brake registers

Kit Includes
Forged One Piece Steel Rotors – B2790
– Superior strength without the concerns of bolts loosening or hats cracking
– .430″ thickness significantly reduces weight over factory rotors
– Accepts 1/2″ & 5/8″ stud kits in 4 1/2″, 4 3/4″, & 5″ bolt circles

Four Piston Aluminum Calipers with Stainless Steel Pistons – B5001
– Aluminum bodies drastically reduce weight
– Pistons are 1.750″ to provide exceptional clamping force
– Stainless steel pistons are corrosion resistant
– Anti-rattle clips reduce brake pad vibration and noise

Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodic maintenance

Housing End Stud Kit – H1135STKIT
– Additional components that are not supplied in most aftermarket systems

Hard Metallic Brake Pads
– Provides high resistance to brake fade
– Recommended for vehicles going over 150 MPH in the 1/4 mile
– Maintains decent starting-line cold holding capabilities
– May leave pad residue on rotors that requires removal when pads are changed

Brake hoses and lines are not included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings

View AllClose