Description
Zero Crossing TDC Sensor, 3-Pin 3/8" dia.
This speed sensor is used to pick up Top Dead Center (TDC) on the front hub of the engine. It is designed specifically for use with MSD-style crank trigger wheel and magnets. It must be used with a RPM input designed for a zero crossing sensor. Designed for use with Racepak data loggers which have the Timing Monitor channels installed:
• V300SD
• V500/V500SD
• Pro II/Pro 1B
• Pro III/Pro IIIA
Related Products
Related Products
Clutch RPM Sensor, 3-Pin, 3/8" dia.
Racepak
$204.95
Zero Crossing RPM Sensor, 3-Pin 3/8” dia. This non-powered sensor is designed for monitoring magnetic pulses. It must be used with an RPM input designed for a zero crossing sensor. This speed...
RAC-800-SS-ZX-3
Wheel Speed Sensor, 3-Pin, 3/8" dia.
Racepak
$204.95
This speed sensor is commonly used to detect either Drive Shaft (ring gear) RPM or Front Wheel RPM. This sensor has a 3/8" fine thread pitch and is triggered using ferrous (steel) material.
RAC-800-SS-MSC-3
Driveshaft RPM Sensor, 3-Pin, 5/16" dia.
Racepak
$204.95
This speed sensor is commonly used to detect Drive Shaft RPM or Wheel RPM. This metal sensor has a 5/16" fine thread pitch and is triggered using magnets. Works with the following Racepak...
RAC-800-SS-MSC-5
Travel Sensor, 0-3"
Racepak
$450.95
These linear travel sensors are designed to monitor even the slightest amount of shock travel or tire shake. These sensors can also be used to determine throttle or clutch position.
RAC-800-LN-TRV3