RPM Sensors

This V-Net module and sensor allow units with a clutch RPM pickup on the harness to add clutch (input shaft) RPM monitoring to determine both clutch slip and transmission slip. Comes with zero-crossing RPM sensor, magnet and V-Net module. For a function...

Zero Crossing RPM Sensor, 3-Pin 3/8” dia. This non-powered sensor is designed for monitoring magnetic pulses. It must be used with an RPM input designed for a zero crossing sensor. This speed sensor is used to pick up Clutch (input shaft) RPM...

This speed sensor is commonly used to detect driveshaft RPM or wheel RPM. This plastic sensor has a 5/16" fine thread pitch and is triggered using magnets. Works with the following Racepak data loggers and dashes:• Pro 1B / Pro...

This speed sensor is commonly used to detect Drive Shaft RPM or Wheel RPM. This metal sensor has a 5/16" fine thread pitch and is triggered using magnets. Works with the following Racepak data loggers and dashes:• Sportsman•...

This driveshaft bracket allows you to fasten your Racepak driveshaft sensor to a 9" center section. Fits all 5/16" sensors and features slotted mount for easy adjustment.

Magnetically triggered switch normally open and closed with magnet passage. Same as supplied with Racepack Computer Systems. Fits 3/8" diameter hole in mount bracket.

This speed sensor is commonly used to detect either Drive Shaft (ring gear) RPM or Front Wheel RPM. This sensor has a 3/8" fine thread pitch and is triggered using ferrous (steel) material.

Zero Crossing TDC Sensor, 3-Pin 3/8" dia. This speed sensor is used to pick up Top Dead Center (TDC) on the front hub of the engine. It is designed specifically for use with MSD-style crank trigger wheel and magnets. It must be used with a RPM input...