Strange Evolution Dynamic Drive Mount Rear Brake Kit, 1967-1980 OEM Small GM Ends & Strange Components, Evolution S Rotors, 4 Piston Billet Evolution 4 Calipers with DTC-30 Semi Metallic Pads B1716WCE

Strange Evolution Dynamic Drive Mount Rear Brake Kit, 1967-1980 OEM Small GM Ends & Strange Components, Evolution S Rotors, 4 Piston Billet Evolution 4 Calipers with DTC-30 Semi Metallic Pads

Designed Specifically for Drag Racing

Evolution Rear Brake Kit
For OEM 1967-1980 Small GM Housing Ends

Requires
• Strange axles and C-Clip Eliminator Kit
• 2.832 in. brake offset

Specify Which Eliminator Kit in Order Notes:
• A1032 - Drag Race Only Kit for Stock Axles 1.400 in.
• A1033 - Street / Strip Kit for Stock Axles 1.400 in.
• A1030 - Drag Race Only Kit for Strange Axles 1.532 in.
• A1034 - Drag Race Only Kit for Strange Axles 1.563 in.
• A1100 - Hybrid Oval Track Kit for Strange Axles 1.773 in.

Evolution S Dynamic Drive Mount (DDM) Stainless Steel Rotors – B2798L / B2798R
• Evolution S Rotor mounts to Billet Aluminum DDM Hat – reducing rotating weight
• DDM system secures the rotor and allows for rotor thermal expansion – drastically reducing warping, coning, and cracking which are common with bolt retention designs
• DDM system design is secured by an internal Spirolox, eliminating heavy bolts and hardware- further reducing rotating weight
• Evolution S rotors are machined and fully ground from Stainless Steel that exhibits 48% greater yield strength at 1,000 degree F compared to carbon steel- further maintaining rotor integrity
• Stainless steel Evolution S rotors are highly resistant to heat and corrosion
• Unique Aero Slot design reduces rotating weight and promotes even heat dissipation- compared to common round drilled holes
• Scalloped design further reduces rotating weight
• 11.250 in. OD / .355 in. thickness

Four Piston Billet Evolution 4 Calipers – B1900
• Stainless steel pistons mitigate heat transfer to brake fluid
• Reverse dish pressure vessel piston maximizes stiffness
• High retraction piston and O-ring design to eliminate drag during acceleration
• Computer finite element analysis (FEA) optimized and field-tested calipers- Evolution 4 design improves piston retraction, pedal feel, and stiffness resulting in improved pad wear and exemplary braking efficiency
• All pistons are 1.750 in. for increased clamping force

DTC-30 Semi Metallic Brake Pads
• Provides the best starting-line cold holding power
• Recommended for vehicles going 150 MPH or less in the 1/4 mile

Aluminum Caliper Mounts
• Billet one piece design
• Eliminates bolts, spacers & nuts that require periodic maintenance

Inner C-clip Eliminator Halves
• Modified halves for the specified eliminator kit
• Maintains same wheel to wheel width as drum brakes
• No pressing required provides easy installation
• New oil seals installed in halves

Need More Wheel Clearance?
Low Profile Caliper Option – OPRB12
Advantages
• Reduces assembly diameter by .354 in.
• Provides additional clearance necessary for some wheels

Brake Hoses and Lines Are Not Included
Calipers are tapped 1/8 in. NPT and supplied with a straight male 3 AN fitting

Use Teflon® tape or liquid on the pipe threads of the fitting
Leave a few threads from the tip uncoated
This will avoid depositing material inside the caliper
Torque fitting to 25 ft lbs